Dishwasher – How to replace the pressure sensor kit (2)

Resolution

Always refer to the safety information in your product’s user manual before carrying out any repair or maintenance.https://www.electrolux.com/support/user-manuals/

WARNING!RISK OF ELECTRIC SHOCK

Before carrying out any repair or maintenance, switch off the appliance and unplug it from the socket.

WARNING!RISK OF INJURY

Always take care when moving appliances. For heavy appliances it’s safest for two people to move them. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect against cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you’re doing any maintenance or repair work that involves springs.

WARNING! RISK OF FINGERS BEING TRAPPED

Wear safety gloves if you’re carrying out maintenance or repair work involving belts.

WARNING!CHOKING HAZARD

Small parts. Not suitable for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before carrying out any maintenance, turn off the water supply to the appliance. Always drain all the water from the appliance. Any maintenance should be done with the appliance standing upright. Any water left inside could damage the electronics if the appliance is laid on its side.

Make sure to use the product only for its intended purpose and check that it’s a compatible part for the product you’re using.

Do not use or install the product if it is damaged.

Please note that repairing it yourself or having it repaired by someone who isn’t a professional can have safety implications if it’s not done properly and may void the warranty. It’s essential that you have the necessary know-how.

HOW TO REPLACE PRESSURE SENSOR KIT (V2)

1. Remove the filter and its housing, then use a small syringe and some old towels to drain the water from the sump.

2. Carefully tilt the dishwasher back and unhook the plinth at the top on each side

3. Unhook the front feet and pull the plinth towards you to remove it

4. Unscrew the PH2 screw for the side panel, then unscrew the three PH2 screws holding the front feet on, on both sides.

5. Remove the two front legs and the bottom panel by pulling both towards you to release them

6. Carefully pull the base down to expose underneath the sump.

7. Unplug the wiring connector from the pressure sensor. Take care not to damage the wiring connector.

8. Using a small flat-blade screwdriver, unhook the clip for the pressure switch on the sump.

9. Pull the pressure switch away from the sump to remove it.

10. NOTE: Before reinstalling, it’s recommended that you clean the sump and air chamber using a cable tie.

11. When assembling, repeat the steps in reverse order