Dishwasher - How to replace the manifold pipe

Applies to:

• Dishwashers

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety glovesif you perform maintenance or repair work involving belts.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE MANIFOLD PIPE, NUT
1. Unscrew the four PH2 screws holding the bottom cover of the dishwasher and then pull the cover towards you to remove.

2. Unscrew the three PH2 screws on the back panel and the two PH2 screws on the top of the right hand side of the panel.

3. Remove the side panel by pulling the back of the side panel off first and then unhook the front of the side panel to release.

4. Unclip the two clips on either side of the top basket and then pull the top basket out and away from the basket runners.

5. Unscrew the 8mm nut on the back of the dishwasher for the water duct.

6. Whilst holding the external manifold, undo the manifold pipe nut inside the dishwasher.

7. Remove the water duct by pulling towards you to release.

8. Pull the manifold pipe nut away from the water manifold.

9. When assembling, repeat steps in reverse order.