Fridge freezer- How to replace the thermostat (5)

Applies to:

• Fridges / Freezers

Resolution

Always refer to the safety information in your product's user manual before carrying out any repair or maintenance work. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always be careful when moving appliances. For heavy appliances, it's safest for two people to move it. Always wear safety gloves and safety boots. Keep safety gloves on at all times to protect against cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you're doing any maintenance or repair work on belts.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Always empty the appliance of all the water, e.g. tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE THERMOSTAT
The thermostat is situated in the top panel

1. Unscrew the top panel by taking out the two screws.

2. Remove the top panel

3. Remove the capillary holder then detach the capillary tube from the holder

4. Remove the plastic tube from the capillary then straighten it

5. Pull out the capillary

6. Take out the dodgy thermostat

7. Take out the control unit from the panel then remove the temperature regulation button

8. Swap out the dodgy thermostat

9. Put the thermostat into the control unit and then secure the control unit into the top panel

10. Reattach the top panel

11. Secure the capillary to the capillary holder. Attach the top panel using the screws