Tumble dryer displays error message E40
Issue
- Tumble dryer displays error message E40
Applies to:
- Tumble dryers
Resolution
1. Check if the door is properly closed.
Make sure that the laundry is not trapped between the appliance door and rubber seal. The cycle won't start with the door open.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Tumble dryer's Condenser LED is on
- Tumble dryer emits unpleasant smells
- Tumble dryer displays error message E60 and does not heat up
- Start - Pause LED flashes on tumble dryer
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer emits unusual noises
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer does not work / does not react
- Tumble dryer does not heat up
- Tumble Dryers - Overview
Book a service
Having issues with your appliance? Book a reliable and professional service from our expert technicians to get your product up and running.
Spare parts & Accessories
Find original spare parts for your appliance in our webshop and have them delivered directly to your door.