Tumble dryer displays error message E80
Resolution
Issue:
- Tumble dryer displays error message E80. It indicates a problem with the cycle selector or the software
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Make sure the cycle selector is not set between two programme options.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- Tumble dryer not drying, not drying properly, too long drying
- Cleaning tumble dryer filters and condenser
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not start / does not work
- Tumble dryer stops after a few minutes of the cycle
- Tumble dryer ends the programme immediately after the start
- Tumble dryer displays a padlock
- Condenser tumble dryer does not dry properly and/or does not heat up and/or shows wrong time duration on the display
- Tumble dryer displays error message EHO, EH0
- Tumble dryer displays error message E50