Clothes are too creased after drying in tumble dryer
Resolution
Issue
- Clothes are too creased after drying in tumble dryer
- Tumble dryer heats up too much
Applies to
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution
1. Choose a suitable drying program.
Use a time program, do not dry too long.
Check your user manual for information about the drying time required for different types of laundry.
Download .
2. Remove the laundry immediately after the end of the programme.
If necessary extend the crease protection phase or use the start time delay (if available).
Note: Wool and duvet programmes have no anti-crease protection.
3. Do not exceed the maximum load stated in programmes chapter or shown on the display.
Was this article helpful?
Related Articles
- Tumble dryer displays error message E60 and does not heat up
- Tumble dryer stops after a few minutes of the cycle
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not stop when the cycle is finished
- How long does a full load take to dry in a dryer – heat pump vs condenser?
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E80