Dishwasher door shifts up during a wash cycle
Resolution
Issue:
- Dishwasher door shifts up during a wash cycle
Applies to:
- Integrated dishwasher
- Freestanding dishwasher
Resolution:
1. Contact the installer.
If your integrated dishwasher has been installed recently, the door panel may be too heavy, or the appliance may not have been installed correctly.
2. Check and, if necessary, wash out the spray arms, and clean the filters at the bottom of the unit in accordance with the user manual before using the appliance again.
If the appliance has been installed correctly, the problem may be blocked or clogged spray arms.
3. Contact an Authorized Service Center.
If your dishwasher is not integrated or recently installed, the dishwasher must be inspected and repaired by an engineer.
Was this article helpful?
Related Articles
- Dishwasher baskets or spray arms are discolored
- How to change the drain filter in my Zanussi dishwasher?
- Symbols and programmes on your Zanussi dishwasher
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher does not / will not start but the power is on
- Dishwasher displays error message i30, drains constantly
- Dishwasher comfort lift basket stuck in the upper position
- Dishwasher displays error message i40, i43 or i44
- Dishwasher displays error code i20 beeps 2 times or LED flashes 2 times
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
Related Articles
- Dishwasher baskets or spray arms are discolored
- How to change the drain filter in my Zanussi dishwasher?
- Symbols and programmes on your Zanussi dishwasher
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher does not / will not start but the power is on
- Dishwasher displays error message i30, drains constantly
- Dishwasher comfort lift basket stuck in the upper position
- Dishwasher displays error message i40, i43 or i44
- Dishwasher displays error code i20 beeps 2 times or LED flashes 2 times
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme