Dishwasher door will not close properly or is crooked
Resolution
Issue:
- Dishwasher door will not close properly or is crooked
Applies to:
- Integrated dishwasher
Resolution:
1. Make sure the appliance is correctly levelled
Try adjusting the appliance feet and checking it again with a spirit level
2. Contact the engineer who installed the appliance to ensure that the latch and door have been installed in accordance with the installation manual.
Misalignment of latches and/or hinges can cause the dishwasher door to not close properly or be crooked
3. Contact an Authorized Service Center.
If the above advice does not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- Misalignment of latches and/or hinges can cause the dishwasher door to not close properly or be crooked
Was this article helpful?
Related Articles
- Dishwasher does not / will not start but the power is on
- Cycle indicator light is flashing on the dishwasher
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly
Related Articles
- Dishwasher does not / will not start but the power is on
- Cycle indicator light is flashing on the dishwasher
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly