Dishwasher settings are disabled
Resolution
If the dishwasher settings are disabled, refer to the suggestions below for step by step instructions.
- The program selection sequence involves selecting the cycle and then the settings, after which the appliance starts, the settings may not have been enabled in time.
- To avoid this, it is possible to select a washing cycle and additional settings with the door open - the cycle will not start until the door is closed.
Was this article helpful?
Related Articles
- Dishwasher does not / will not start but the power is on
- Cycle indicator light is flashing on the dishwasher
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly
Related Articles
- Dishwasher does not / will not start but the power is on
- Cycle indicator light is flashing on the dishwasher
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly