Iron Aid dryer does not start
Resolution
If the Iron Aid tumble dryer does not start, fill the steam tank up to the MAX level.
- Check the contents of the condensation and steam water tank. This is also indicated by the LEDs on the right side.
- If the icons are still illuminated , contact an Authorized Service Center.
You can contact an Authorized Service Center by clicking on the link below.
Was this article helpful?
Related Articles
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer displays error message EHO, EH0
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer displays error message E40
- Cleaning tumble dryer filters and condenser
- Tumble dryer's door will not open or is defective / broken
- Tumble Dryers - Overview
- Tumble dryer blows fuses / trips RCD circuit breaker
- Light in the drum of the tumble dryer does not switch off