Oven displays error message C1, C2, C3 or C4
Issue
- My oven shows error code C1, C2, C3 or C4 on the display
Applies to:
- Ovens with Pyrolitic Cleaning function
Resolution
If your oven displays error message C1, C2, C3 or C4, refer to the suggestions below:
DISPLAY CODE | DESCRIPTION | TROUBLESHOOTING |
C1 (*) | Telescopic rails during pyrolytic treatment. | Remove the telescopic rails and all accessories from the oven compartment before activating the pyrolytic function. |
C2 (*) | The cooking thermometer (Food Sensor) is in the connector during the pyrolytic treatment. | Remove the cooking thermometer before activating the pyrolytic function. |
C3 (*) | Open door during the pyrolytic treatment. If the door is open, you cannot perform the pyrolytic treatment. | Make sure to fully close the oven door before the pyrolytic function is activated. |
C4 (*) | The Plus Steam button is activated while switching on the pyrolytic treatment. | Press the Plus steam button again to unselect Plus steam before switching on the pyrolytic function. |
If the problem persists, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- Electric grill - open door grilling
- Temperature on the oven's display differs from the measured temperature
- Steam oven uses too much water during Sous Vide cooking
- Poor baking / roasting results
- Oven steam self - cleaning function
- Oven pyrolytic self - cleaning function gives poor results
- Oven general use / cleaning tips
- Oven front panel / door gets hot
- Measuring internal temperature when roasting / cooking meat
- I can hear a constant beep noise / my oven's display shows 400