Washing machine displays error message E90, E91, E92, E93 or E94
Resolution
Issue
- Washing machine displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Connected appliances - The application cannot connect to the appliance
- The door of the washing machine cannot be opened
- How to clean and maintain your Zanussi washing machine and extend its life
- Grey marks on laundry after washing in washing machine
- The washing machine drum resists when you try to turn it by hand
- Laundry is stiff or hard after washing in washing machine
- How can I access the filter in my Zanussi washing machine?
- Washing machine displays error message E40, E41 or emits 4 beeps / 4 flashes
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- Washing machine does not work / does not react