Washing machine displays error message Eb0, Ebo or emits 11 beeps / 11 flashes
Resolution
Issue:
- Washing machine displays error message Eb0, Ebo or emits 11 beeps / 11 flashes. It may indicate problems with the too low voltage of the power supply.
Applies to:
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution:
1. Check the voltage by plugging in the appliance somewhere else and then trying it again.
2. Remove any extension cable and try again.
3. Check whether the product is connected to ground in the electrical installation.
Plug the machine into a grounded socket and try again.
4. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
5. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
- Report error code: DR
Was this article helpful?
Related Articles
- The door of the washing machine cannot be opened
- Connected appliances - The application cannot connect to the appliance
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Why is there water or moisture is in my washing machine before the first use?
- Washing machine's door opens during cycle
- Washing machine's door can be opened and water runs out onto the floor
- Washing machine produces pale streaks on laundry or emits a sour smell
- The new washing machine shows visible signs of damage
- Washing machine blows fuses / trips RCD circuit breaker
- Clothing care symbols on labels