Washing machine pumps continuously and produces foam
Resolution
Issue:
- Washing machine pumps continuously and produces foam
Applies to:
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution:
1. Switch the machine off and clean the drain pump and filter.
If the washing machine pumps continuously and produces foam it indicates, a lot of soap which produces a lot of foam is used, causing the level system can become clogged.
Clean the pump and fluff filter, including the pump blade (if the pump blade is visible, rotate it with a pencil and refit the filter).
For detailed procedure refer to the user manual supplied with your appliance. Download the .
2. Run a hot wash (90 degrees) without any soap in order to flush any soap residues out of the machine.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- The door of the washing machine cannot be opened
- The new washing machine shows visible signs of damage
- Washing machine stops in the middle of a cycle
- Important Update: iOS 16.x No Longer Supported for AEG/Electrolux Apps
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Fabric conditioner does not dissolve in my washing machine
- Washing machine displays an error code, how to fix it?
- Washing machine displays padlock - Zanussi
- Grey marks on laundry after washing in washing machine
- Cleaning the washing machine’s rubber seal if it's dirty