Washing machine's door can be opened and water runs out onto the floor
Resolution
Issue:
- Washing machine's door can be opened and water runs out onto the floor
Applies to:
- Front loaded washing machine
Resolution:
1. Start a draining cycle before turning off the machine and opening the door, otherwise the water will run out onto the floor.
2. Contact an Authorized Service Center.
If the door can be opened with water in the machine and the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- If a wash cycle with a "Rinse Hold" was chosen and the machine was turned off by using the cycle selector or disconnecting it from the power, the door can be opened after a few minutes, even though there is water in the machine.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Connected appliances - The application cannot connect to the appliance
- Grey marks on laundry after washing in washing machine
- The door of the washing machine cannot be opened
- Washing machine displays error message EF0, EFo, EF3 or emits 15 beeps / 15 flashes
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- Washing machine does not heat water, and does not display an error message
- How can I access the filter in my Zanussi washing machine?
- Washing machine’s fluff filter is jammed, cannot be removed
- Laundry is stiff or hard after washing in washing machine
- Washing machine displays error message E80 or emits 8 flashes